PolyPro PPS-PAC Instalační příručka

PolyPro®Installation InstructionsPolyPro Single-Wall Gas Vent System for Category II & IV Gas-Burning Appliances

10Lochinvar 2" installation (Fig.14)1. Slide PolyPro pipe w/ PVC adapter into oblong hole and down. Brackets will point away from the wall, on

11Figure 18EXHAUSTAIR INLETFigure 17TERMINATION CAPFLASHINGSTORM COLLARSUPPORT CLAMPVertical single pipe (Fig.19)1. Locate penetration (Fig.16)2. C

PolyPro® and GreenVent® are registered trademarks of M&G DuraVent, Inc.All rights reserved, ©2012 M&G DuraVent is a member of M&G Group.

A MAJOR CAUSE OF VENT RELATED FIRES IS FAILURE TO MAINTAIN REQUIRED CLEARANCES (AIR SPACES) TO COMBUSTIBLE MATERIALS. IT IS OF THE UTMOST IMPORTANCE

3PolyPro Single-Wall Gas Vent SystemFor the most up-to-date installation instructions, see www.duravent.comPolyPro®CONTENTSLISTING. . . . . . . . . .

4LISTINGListed to ULC S636 Rated Class IIA, IIB, and IIC vent systemmaximum temperature 230°F (110 °C)maximum positive pressure 15 in-w.c. Massachuset

5 The vent system must be compliant in accordance with local code requirements and appropriate National Codes: In the US: NFPA 54 / ANSI Z223.1 Natio

Figure 2PUSH DOWN TO LOCKPRY OUT TO UNLOCKVERIFY GASKET IS SEATED IN FEMALE END OF PIPEMALE ENDFEMALE ENDFigure 3APPLIANCE CONNECTION: 2" - 4&

INSTALLATION1. PolyPro vent pipe lengths may be cut to length. (Fig.6) • Cut square (not at an angle) to the end of the pipe. • Remove burrs be

8TERMINATIONS:Horizontal Single Pipe (Fig.10)1. Locate penetration in wall2. Cut or cut and frame hole (Table 3)3. Attach Inner Plate to wall4.

94. Slide cap through exterior wall plate into hole from outside building• Cap must be installed level or sloped 1/8" per foot away from applia